98 results for 'PT-130-CMC-6009'

#27 CMC Toggle Switch Plate

This Tilt and Trim Toggle Switch Plate, CMC-51380, is ready to ship to help repair your tilt trim unit.

#26 CMC Toggle Switch Plate

This Tilt and Trim Toggle Switch Plate, CMC-51380, is ready to ship to help repair your tilt trim unit.

#22 CMC Toggle Switch Plate

This Tilt and Trim Toggle Switch Plate, CMC-51380, is ready to ship to help repair your tilt trim unit.

#22 CMC Position Indicator Gauge Kit P/N 6077

his kit is used to add a gauge to your outboard Jack plate from CMC Marine. Simple installation using your small hands and lots of patience. Buy this Gauge Kit for CMC Jack Plate 6077 to have a safe...

#25 CMC Toggle Switch Rubber Boot

This Tilt and Trim Toggle Switch Rubber Boot, CMC-7124, is ready to ship to help repair your tilt trim unit.

#26 CMC Toggle Switch Rubber Boot

This Tilt and Trim Toggle Switch Rubber Boot, CMC-7124, is ready to ship to help repair your tilt trim unit.

#21 CMC Toggle Switch Rubber Boot

This Tilt and Trim Toggle Switch Rubber Boot, CMC-7124, is ready to ship to help repair your tilt trim unit.

#04 CMC PL-65 Starboard Side Transom Rail

This starboard side transom rail, CMC-6004, is ready to ship to help repair your jack plate.

#8 CMC PL-65 bottom Spring Pin

This bottom spring pin is made of 304 stainless steel and is 1/2" X 1 1/2"

#9 CMC PL-65 top Spring Pin

This top spring pin is made of 304 stainless steel and is 1/2" X 3 1/2"

#12 CMC PL-65 Bronze Bearing (Set of 4)

These bronze bearings are the part that slides in the grooves in the motor rails. Qty of 4 required to assemble a jackplate. Two for the starboard side and two for the port side.

#13 CMC PL-65 Nylatron Flat Washer (Set of 8)

These nylatron flat washers are the part that slides outside the grooves on the motor rails. Qty of 8 required to assemble a jackplate. Four for the starboard side and for for the port side.

#14 CMC PL-65 Aluminum Flat Washer (Set of 4)

These aluminum flat washers are the part that prevents the bolt from cutting into the nylatron flat washers.1/4" X 3/4" X 2" aluminum flat washer Qty of 4 required to assemble a jackplate. Two for...

#16 CMC PL-65 External Tooth Lock Washer (Set of 8)

These external tooth lock washers are the part holds the top bracket to the motor rails and the bottom bracket to the transom rails.1/2"" external tooth lock washer is made from 410 Stainless Steel...

#15 CMC PL-65 Hex Head Cap Screw (Set of 8)

These hex head cap screws are the part holds the top bracket to the motor rails and the bottom bracket to the transom rails.1/2 - 13 X1" hex head cap screw Qty of 8 required to assemble a jackplate...